Ballistol for Gunsmiths

A gunsmith goes through oil, solvent and grease faster than most. Universal Oil cleans and protects in one pass and does not gum up actions. Robla Solo Mil strips copper from bores, GunCer Ceramic Grease handles the high-load parts, and Quick Blueing touches up worn finish at room temperature.

Supplied direct by Ballistol UK, the official UK distributor. Made to the same formula since 1904.

Products for large orders

Retail prices shown. Large orders are quoted at trade prices, and you can mix products and sizes in one order.

Benefits

Fewer products on the bench

Universal Oil cleans and protects in one pass.

Does not gum up

It does not resinify, so actions and triggers stay free.

Grease for high loads

GunCer works from -50°C to +150°C and is neutral towards bluing, wood and paint.

Touch-ups without tanks

Quick Blueing works at room temperature with no heat.

Application

  • Robla Solo Mil

    Plug one end of the barrel, pour in Robla Solo Mil and let it work on the copper. Push a soaked felt through for light residue.

  • Guncer Ceramic Grease

    Clean the parts first, then apply sparingly with the dosing tip or a small brush.

  • Quick Blueing

    Degrease the steel, remove any rust with fine steel wool and degrease again. Apply evenly, leave it to react, wipe, repeat for a darker finish and seal with oil.

  • Ballistol Universal Oil

    When the work is finished, wipe a thin film over the metal before the gun goes back to the customer.

  • Scherell Stock Oil

    Rub a small amount into refinished walnut, let it soak and buff off. Build up thin coats.

Areas

Strip-down bench

Actions, triggers, springs and small parts.

Barrel work

Bores being inspected or measured.

Finishing

Blueing touch-ups and stock refinishing.

Handover

Finished guns protected before collection.

Uses

  • Cleaning actions, triggers and small parts during a strip-down
  • Removing copper fouling before inspecting a bore
  • Greasing locking lugs, hinge pins and choke threads
  • Touching up blueing on screws, pins and worn edges
  • Protecting finished work before it goes back to the customer
  • Oiling walnut stocks after refinishing

Ordering in volume

Workshops tend to buy the larger sizes, such as Universal Oil in 5 litres and Robla Solo Mil in 1 litre, and reorder every few months. If you also sell to customers, add shelf sizes to the same order.
  • Tell us what you need, roughly how much and how often. We reply with a quote at trade prices.
  • Mix products and sizes in one order. Tell us if you need something that is not listed here.
  • If you reorder regularly, tell us how often and we will plan stock around you.
  • Technical and safety data sheets for every product are on our technical data page.
  • We confirm price and delivery before anything is sent, then invoice you.

Want to sell Ballistol in your shop instead? See trade and wholesale accounts.