Ballistol for Injection Moulders

Mould tools are expensive steel, and a tool put away damp can come back with rust on the cavity. Injection moulders use Universal Oil to protect tools in store and free seized fixings, Cold Degreaser to clean the oil off tool faces before a run, and H1 Food Oil on machinery where parts for food packaging could see incidental contact.

Supplied direct by Ballistol UK, the official UK distributor. Made to the same formula since 1904.

Products for large orders

Retail prices shown. Large orders are quoted at trade prices, and you can mix products and sizes in one order.

Benefits

Tools protected in store

A thin film of Universal Oil keeps damp off mould steel between runs.

Clean faces before a run

Cold Degreaser removes oil and grease from metal and plastic before production starts.

Dry lubrication on guards

PTFE Spray suits guard doors and slides and does not pick up dust.

H1 for food packaging lines

H1 Food Oil is NSF H1 registered and has no smell or taste.

Application

  • Ballistol Universal Oil

    Clean the tool, spray a thin coat over the steel and leave it a few minutes. Wipe off the excess so a light film stays on the faces before the tool goes into store.

  • Cold Degreaser 200ml

    Before the next run, spray an even coat over the tool faces to lift the oil and wipe them clean.

  • PTFE (Teflon™) Spray 200ml - Dry Lubricant

    Clean and dry guard runners and slides, shake the can and spray a thin coat from 15 to 20cm. Let it dry before running the press.

  • Ballistol H1 Food Oil

    Apply sparingly to conveyors, gears and moving parts on food packaging lines and wipe off the excess. It is compatible with most plastics and rubber.

Areas

Tool store

Mould tools laid up between runs.

Press shop

Guard doors, slides, clamps and fixings.

Tool changes

Faces and fittings being cleaned before production.

Food packaging lines

Conveyors and machinery where incidental food contact is possible.

Uses

  • Protecting mould tools from rust while they are in store
  • Degreasing tool faces before a run
  • Freeing seized clamps and bolts at tool changes
  • Lubricating guard doors and slides with dry PTFE
  • Lubricating conveyors and machinery on food packaging lines with H1 Food Oil
  • Removing grease and label glue from machine panels

Ordering in volume

Moulders tend to order around tool changes and planned shutdowns, with Universal Oil in 5 litres for the tool store and sprays at each press. Sites making food packaging usually add H1 Food Oil to the same order.
  • Tell us what you need, roughly how much and how often. We reply with a quote at trade prices.
  • Mix products and sizes in one order. Tell us if you need something that is not listed here.
  • If you reorder regularly, tell us how often and we will plan stock around you.
  • Technical and safety data sheets for every product are on our technical data page.
  • We confirm price and delivery before anything is sent, then invoice you.

Want to sell Ballistol in your shop instead? See trade and wholesale accounts.