Ballistol for Toolmakers

Press tools, moulds and jigs take weeks to make and can be marked by one damp weekend. Toolmakers use Universal Oil to protect ground and polished steel between operations and in storage, and because it is mildly alkaline it neutralises the hand sweat that leaves fingerprints in rust. Cold Degreaser takes the oil back off before tryout or assembly.

Supplied direct by Ballistol UK, the official UK distributor. Made to the same formula since 1904.

Products for large orders

Retail prices shown. Large orders are quoted at trade prices, and you can mix products and sizes in one order.

Benefits

No fingerprint rust

Universal Oil neutralises the acidic hand sweat that marks polished steel after handling.

Stays thin in storage

It does not resinify, so a tool laid up for months is not left with a sticky film.

Clean for assembly

Cold Degreaser removes oil and grease from components before they are fitted.

Dry film on slides

PTFE Spray lubricates sliding parts on jigs and fixtures without holding grinding dust.

Application

  • Ballistol Universal Oil

    Wipe the steel clean and spray or wipe on a thin coat. Leave it a few minutes, then wipe off the excess with a dry cloth so a light film stays on every face.

  • Cold Degreaser 200ml

    Spray an even coat over the part to lift the protective oil and wipe it off before assembly or tryout.

  • PTFE (Teflon™) Spray 200ml - Dry Lubricant

    Clean and dry the slide, shake the can and spray a thin, even coat from 15 to 20cm. Let it dry for a few minutes before use.

  • Silicone Oil Spray, 65ml

    Wipe rubber seals and O-rings clean, apply a thin coat with a cloth and buff off the excess.

Areas

Grinding and finishing

Ground and polished faces waiting for the next operation.

Fitting bench

Components handled during fitting and spotting.

Tool store

Press tools, moulds and jigs laid up between runs.

Assembly

Parts that need degreasing before they go together.

Uses

  • Protecting ground and polished tool steel between operations
  • Preventing fingerprint rust on parts handled during fitting
  • Laying up press tools, moulds and jigs in storage
  • Degreasing components before assembly or tryout
  • Freeing seized screws and dowels during a rework
  • Lubricating sliding parts on jigs and fixtures with a dry PTFE film

Ordering in volume

Toolrooms usually keep Universal Oil in 5 litres for the bench and 400ml sprays for tools going into store. Reorders tend to follow the workload, so a quote based on a typical month works well.
  • Tell us what you need, roughly how much and how often. We reply with a quote at trade prices.
  • Mix products and sizes in one order. Tell us if you need something that is not listed here.
  • If you reorder regularly, tell us how often and we will plan stock around you.
  • Technical and safety data sheets for every product are on our technical data page.
  • We confirm price and delivery before anything is sent, then invoice you.

Want to sell Ballistol in your shop instead? See trade and wholesale accounts.